How Do I Get a Painting Onto A Stretcher? - painting stretchers
I have some pictures that are from the table and rolled. I want to get in and out on a stretcher. I did not notice during a painting class tutorial "How to Build a stretcher.
Where do I start looking for someone to do it for me? These photos were personal and not standard.
Saturday, January 9, 2010
Painting Stretchers How Do I Get A Painting Onto A Stretcher?
Subscribe to:
Post Comments (Atom)
2 comments:
Follow the instructions in the previous answer. But do not just want to paint the face in a warehouse sale or garage floor asked to do so. Less than or piece of paper and tape to the ground the work area.
You can save your shopping stretcher pliers in a hobby or craft or art. I recommend this as they have realized long ago the flat surfaces so you material, without a hole in it to take, how to regulate tweezers. They are not so expensive. If you have a tight budget, check with other artists and see if you can borrow a pair. (remember, they once again!)
If you do not want to do it yourself, take a workshop on good decisions. In general, you can do for you. It is not cheap.
If you do not want to create your own or pay someone to be able to do it for you, then the measure of each table and an approximation to a standard size can. To buy at hobby stores or art supply ready-made stretcher and the size you need, and assemble - simple. Now the canvas stretched over them instructions. I've always StArt in the middle of the page, then do half of each page and the center of the bottom with a heavy stapler (staples on the back of the board of the framework has to cover parentheses), and! Work on all sides until you have the corners, fold carefully (you may get some of the excess screen adaptation of a time in Nice.) And staple the soil. Make sure that all parties make the wrinkles around the solstice. When the cover moves too much and has already cut more than everything, then a thin cotton cloth on the corner sometimes, and then apply the iron to a minute to make flat. if it is on color, not gt long and very hot iron for a few seconds, so watch it again to leave, rather than too long a time, and the merger of the painting!
It is not hard to do. All U need to do is a wooden frame to the desired size, 2by4 or 4by4 inch wood, you do better, I think.
Painting the place to head to the frame in the back and then base / paintings from the frame to make the top half.
then do the opposite, jaw slightly or canvas and staple / tack, clips can be used.
Painting do the same thing again in the other two sides, and rotate to opposite sides so tightly around the frame.
very clear and basic foods available.
Post a Comment